1997 - 2004 f150 4.6L Torque Specs


2004 f150 Rear End Torque Specs

Click the area you are looking for!




f150 4.6L Repair Information

f150 4.6L Rear End Repair Information

Here you can find information regarding repairs to the f150 rear end system. These repairs include the rear control arms installation, the rear swaybar information and bolt torque specs, the rear diff fluid change procedures, and the rear end watts system installation. All of these repairs and procedures include in depth details on how to perform the replacement and or repair. They also contain all the detailed torque specs needed for each bolt involved in the repair.

Rear Stabilizer Bar Installation

f150 Rear a Arms
The rear stabilizer bar on an f150 consists of a large metal bar that connects to both ends of the vehicle. The end connections connect via nuts called link nuts which are torqued down to 75 ft-lbs. The bar is held in place by a set of brackets that connect to the vehicle frame and these bracket bolts also torque down to 75 ft-lbs.

 

 

 

 

f150 Stabilizer End Link Nuts Torque Specs : 75 ft-lbs

f150 Stabilizer Bar Bracket Torque Specs : 75 ft-lbs

 

Rear Differential Fluid change

f150 rear end fluid change
The first step in replacing your rear end differential fluid is to jack the rear end of the vehicle up into the air. Be sure to use safety precautions so that no injuries occur. With the vehicle in the air you will have clear access to the rear differential. If you want to check the current fluid level you can remove the fluid fill plug which is a 3/8's ratchet sized bolt located about half way up the differential. If the fluid level is full the fluid should be directly below the level of the plug. If it is lower then your are currently low on fluid. To replace the fluid inside the diff you must remove the plate and allow for the fluid inside to seep out. Be sure to have a container to catch the fluid. Once the fluid stops flowing you can reinstall the plate by using some silicon sealant to help prevent leakage. The bolts for the plate should be torqued to 37 ft-lbs. With the plate reinstalled you can now take your new fluid and fill the rear end up through the rubber plug hole. Once done reinstall the plug to 25 ft-lbs and ensure that there are no leaks at the bottom of the cover.

f150 Differential Cover Torque Specs : 37 ft-lbs

f150 Differential Fill Plug Torque Specs : 25 ft-lbs

 

Rear Shocks Installation

f150 Rear shock
To replace the rear shocks on a f150 you will need to remove two sets of bolts/nuts. The first being the one located on the top of the shock. This one can be accessed by the truck or through the side of the vehicle with a wrench. Once this one has been removed the next bolt is located on the bottom of the vehicle. Once the bottom bolt has been removed the shock can be lowered out of the vehicle. The new part can now be placed in the vehicle much the same way that the old one has been removed. When tightening the bolts back up make sure to torque the top bolt to 75 ft-lbs. The lower bolt on the shock must be tightened to 75 ft-lbs.

f150 Rear Shock Upper Bolt Torque Specs : 75 ft-lbs

f150 Rear Shock Lower Bolt Torque Specs : 75 ft-lbs

 


Rear Suspension Torque Specs
Stabilizer Bar Bracket Torque Specs 75 ft-lbs
Stabilizer Endlinks Torque Spec 75 ft-lbs
Shock Upper Nut Torque Spec 75 ft-lbs
Shock Lower Nut Torque Spec 75 ft-lbs
Rear Differential Torque Specs
Diff Plate Torque Specs 37 ft-lbs
Rear Differential Fill Plug Torque Spec 25 ft-lbs